Compressors

           Creating an industry standard

 

The following is a complete list of parts that are NEW in any reconditioned compressor purchased from Farley’s. Item numbers from “Vilter” parts reference sheets are used for clarification.

#102   Cylinder cover bolts #305   Oil pump body gasket
#104   Water jacket gaskets #306   Oil Pump
#106   Cylinder cover gaskets #307   Oil pump cover gasket
#107   Valve retaining studs #308   Oil pump cover seal
#108   Valve retaining studs #315   Oil filter
#109a  Suction screen bags #323   Oil filter canister bolts
#110   Suction screen gaskets #325   Rear bearing cover gasket
#112   Suction screen cover gaskets #326   Rear bearing cover bolts
#113   Drain and fill valve #327   Oil pump cover bolts
#114   Oil screen gasket #338   Oil thermometer
#118   Internal relief valve #339   Crankcase heater
#119   Internal relief gasket #402   Cylinder liner “O” rings
#121   Internal relief cover bolts #402a  Cylinder liner roll pins
#122   Handhole cover gasket #405    Unloader lift springs
#124   Oil sight glass #407   Suction valve plates
#128   Handhole cover bolts #410   Unloader piston ring steel
#201-208 Oil relief kit #410a  Unloader piston “O” ring
#213   Bearing cover bolts Hex-head #501   Compression rings
#215   Bearing cover bolts #502   Oil rings
#217   Rotary shaft seal #505   Piston pin
#218   Shaft seal cover gasket #506   Piston pin bushing
#219   Shaft seal cover bolts #509   Connecting rod nuts
#220a Shaft seal drip tube #511   Connecting rod bearings
#224   Front bearing locknut #512   Connecting rod bolts
#227   Front main bearing #513   Discharge valve locknut
#231a Rear main bearing #515   Discharge diaphragm plates
#232   Rear bearing retainer bolts #518   Discharge valve bolt
#519   Helical valve springs

Final assembly is completed by qualified mechanics using all of the NEW parts listed above and giving you the BEST warranty available. 24 months from start up under normal operating conditions, 24 months from date of shipment. All warranties are FOB Astatula FL.Then they are disassembled completely and cleaned, frame and external parts are inspected for reuse,
Cylinders are cleaned, honed and seats are lapped. Connecting rods all receive new bushings and rod bolts. Discharge valve assemblies are cleaned, lapped and reassembled with new diaphragms. Pistons are cleaned inspected and receive new rings and piston pins. Crankshafts are cleaned, polished and receive new main bearings and connecting rod bearings. Front bearing housing is cleaned and updated to modernize the compressor. All tubing and fittings are replaced with new materials. All Unloader valves and tubing are new. Oil coolers are cleaned and Pressure tested, then reused. Last step is pressure test the head cooling and block then final painting.

 

Vilter is a register trademark of Emerson and Farleys is not an authorized dealer and all parts sold by Farleys are covered by Farleys and not Vilter or Emerson